INSTRUCTIONS
Ensure the glowplug is unscrewed completely so the threaded portion clears the glowplug port. Thread the puller core through the puller sleeve enough to fully expose the grooved section. Slip the grooved end of the puller core over the hex head of the glowplug. Make sure that the head of the glowplug is completely inside the tool or you will damage the threads. Turn either the puller sleeve or the puller core until the sleeve is snug against the engine head. In most cases, you need only to “wiggle” the tool slightly by hand and re-snug a few times to pull the swollen glowplug. Occasionally though, you may need to use wrenches to turn either the puller core or the puller sleeve. You must be very careful when doing this. IF THE TOOL STARTS BINDNG AND EXCESSIVE FORCE IS NEEDED, LOOSEN AND RE-SNUG. Using a lubricant helps as well. On the no. 1 cylinder you will have to turn the sleeve only due to the close proximity to the alternator bracket.
WARRANTY
This tool is warranted for up to one year from the date of purchase. Should the tool be impaired due to manufacturing defects, a replacement will be given in exchange for the impaired one. In the event of obvious misuse or any use other than that described in the instructions, this warranty will be void.